New Posts

One weekend of use probably less then 20miles indoor kept one has super super slow leak, probably sand in bead $1000obo

• A/C Ducted - Ducted • A/C Bedroom - 13.5 BTU • Bunk Ladder • Custom Carpet Kit • Double Carpet Padding-Bdrm • Ducted Furnace • Flush Floor Tie Downs • Glass Shower Enclosure • Laminated Counter Tops w/Edge • LED Lighting • Microwave Oven • Rear Electric Beds/Couch • Roller Shade Window Coverings • Stereo/Amp/DVD/BT/Subwoofer • TV LCD - 40” • Wardrobe Slide Out • 40 Gal Fuel Tank w/Pump Station • Aluminum Frame Fiberglass Construction • Awning - Power w/LED • DSI Water Heater • Exterior Ladder • Front Diamond Plate • Generator Onan 5.5 (330 hrs) • Ground Effects Light Pckg • Keyless Entry Door • One Piece Roof Membrane • Power Jacks Front • Pressure Washer • Sani Flush - Black Tank • Sink Cover • Spare Tire • TV Antenna w/Cable Hook-Up • 160 Solar w/Inverter • Diamond Plate Flooring - Cargo Area • Livingroom Sofa Slide Out • 120 Gal Fresh/50 Gal Gray/50 Gal Black • New Batteries • External Gas Grill Hookup Plumbed Low miles and usage. Must see to appreciate. $52,000 obo Text or message (702)290-2015

See it run and buy it @ Doghouse Repair in Pahrump, Nv 10.3:1 compression running on 91 octane TEXT us @ 7757279344 to get videos & many more pictures sent to you TEXT us for more detailed information or questions you have $6000 plus tax and core (no core, add $500)

I have one of these gears that I purchased at $129 for my Lippert Happijac bed lift (2013 Attitude 34’) that ended up not being needed once disassembled. My issue ended up being the horizontal chains across the top that attach to the gears for the vertical lift rails. The horizontal chains were SO loose from the factory, which do not have any adjustment on them, allowing them to skip on the gear causing the bed to get out of wack on each corner. I made a set of chain tensioners and adjusted the vertical chains to ensure the issue was resolved. When I find some time I will do a thread on my issue vs the gear failure issue. Once apart I realized my gear from the factory was already an aluminum gear. (See pic of far right gear in GB) With that said, I no longer need the gear I purchased and will sell it for $75 to the first buyer. My recommendation, if you are having an issue is to pull the motor and gearbox first as to ensure it fits your model as there seemed to be a slight differences in this gear and mine without removing mine from the shaft. (Same size and # of teeth but mine looks to not have the keyway running completely through the gear. May still have worked but did not want to disassemble my good gearbox any further than needed. Lots more pics available that I will try and put together in another thread and come back here to update with a shortcut. Tozlakes

2011 Polaris XP 900LE One owner XP 900. This thing is in great shape and never abused. I’ve never had any issues with it and have always used Polaris oil and filter. It only has 2411 miles on it and it has the original belt! You read that right, I have NEVER changed the belt. It has the stock cage that has been lowered in the rear and seatbelt bar welded in. Cage was powder coated red and custom aluminum roof added. Here are a list of items done to it. BS Sand race seats Simpson 5 point belts Dragonfire wheel with quick release Switch plate on dash SSV Works overhead stereo Axia rear view mirror K&N filter- inner and outer Gibson slip on exhaust Tusk trunk bag Lighted whip Doors DWT black rims with Maxis Bighorns 26x9-12 front 26x12-12 rear DWT sand Doonz tire set 25.5x11-12 front 25.5x13-12 rear It sits 70inch wide on the front and 72.5inch wide on the rear with the offset rims. If you need it narrower you could put stock rims back on it. This thing has normal wear and tear, but it is in really good condition for its age. It has a newer battery and is hooked up to a battery tender. I think I still have the stock seats for it as well. It runs amazing and is still a super fun time. I’m not looking for trades. If you have any questions CALL ME!! Pink in hand and current sticker, $12,500 OBO. 559 840 7780.

Text us for internal specs & more pictures See the build & more on our Instagram page Doghouse Repair $2200 plus plus

SOLD

See it run and buy it @ Doghouse Repair in Pahrump, Nv 9.8:1 compression running on 89 octane TEXT us @ 7757279344 to get videos & many more pictures sent to you TEXT us for more detailed information or questions you have $5800 plus tax and core (no core, add $500)

Have a charlyn question, when the car is not running I am get a lot of play in the steering. If center of the wheel is 12 clock it moves to about2/3 clock and with the car running it's going from 12 to about 1/2 clock.with out the tires moving. Anyone know much about thees? I assuming it needs to be rebuilt anyone know of anyone in the High desert area?

Thanks for sharing, Nick! Great to finally camp and dune together. Super fun weekend even with the crap weather! lol

Hey guys (whoever is even reading this lol), our plans to feed everyone on Saturday fell through so you are on your own for lunch. Sorry! but we'll still be doing the raffle around 12:30/1pm. The rest of the weekend's format remains the same. Details on the news post.

Steve, We live in Boise ID and have a 5 seater 2006 Wuerth Sandrail we are selling. It is like new. 2 sets of tires. I dont know alot about it so feel free to reach out to my husband Kevin via the email and he will give you the details. Asking 20K. Worth looking at!! thanks

Welcome back! And no problem combining accounts. I remembered your screen name from way back. It's crazy the things I remember but much more important things just seem to slip away. Dave right?

Chenowth sand rail, good running 1915cc VW, bus trans, just replaced rear main seal and front crank seal, just went through all wiring and added new switch box, new LED lights, LED whip, three sets of rear wheels, newer set of rear paddles currently on car, converted rear drums to disc, car is great and starts every time. $2450. Make me an offer I need it sold! If the ad is up then the rail is still available. B8055109-13E0-48BC-9CB1-337C7B46A3CBsegment_video_2.mp4

@sandypinesaz yes it still is.

All rims polished today! This rail is sweet

Kelly's RV