Jump to content

yamaha worrior wont run unless choke is on


draggindre
 Share

Recommended Posts

just had that happen on my daughters predator, clogged pilot jet.tried to clean it was varnished pretty good. went to osh and got the exact size drill bit to that hole. 1 pass clean assembled works perfect. btw: thanks dan @ powerhouse he diagnosed it over the phone !!

Link to comment
Share on other sites

Agreed, I have a raptor 350, pretty much same engine. You can actually remove the jets without taking off the carb. Just loosen up the two clamps with an allen wrench that hold the carb to the air box and head elbow, pinch off the fuel line and remove from carb, twist towards the clutch handle side and with a small philips head screwdriver, remove the 4 screws on the bottom to remove the bowl. Take care to notate that there is a longer screw than the other 3, this one holds the small bracket for your carb adjust. Remove the pilot jet, the smallest one, with a flat head screwdriver, I then just got a piece of old cable TV wire, stripped it and used the center copper wire to clean mine out, worked like a charm. I suggest you give the whole carb a good spray with carb cleaner while you have it open and remove your main jet as well and clean it out also. When you tighten the jets back up, don't over tighten or you will make the job for you a lot harder in the future.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • VIP RV

×
×
  • Create New...